Alcides Lopes Leao

Professor
Bioprocesses and Biotechnology
Universidade Estadual Paulista
Brazil

Professor General Science
Biography

Alcides Lopes Leao holds a degree in Agronomic Engineering from Universidade Estadual Paulista Júlio de Mesquita Filho - UNESP (1981), a master's degree in Agronomy (Energy in Agriculture) from UNESP (1987) and a Ph.D. from Forestry - University of Wisconsin - Madison (1993) in the USDA-FPL (Forest Products Laboratory) University of Wisconsin - Madison, USA. He was national advisor to SEBRAE - Service of Support to Micro and Small Companies in the areas of Environment, Waste and Natural Fibers. He has been a professor at São Paulo State University Júlio de Mesquita Filho since 1997, where he was admitted in 1985. He has experience in the area of ​​Bioenergy and Materials Engineering and Metallurgy, with emphasis on Non-Metallic Materials. Mainly engaged in the following subjects: environmental management, composites, natural fibers, recycling, biomass energy and industrial, agricultural and urban (trash) waste management.

Research Intrest

Use of agro-industrial waste;Development and technology in bioproducts, bioprocesses and biomaterials, environmental management, composites, natural fibers, recycling, biomass energy and industrial, agricultural and urban (trash) waste management.

List of Publications
OLIVEIRA, ADRIANA FERLA DE; GOMES, GLAUCIO JOSÉ; OLIVEIRA, LUCIANO CAETANO DE; Lion, Alcides Lopes . The performance of curauá fiber as sorbent of diesel and biodiesel oils . Acta Scientiarum. Technology (Online) , v. 38, p. 295-300, 2016
DAYS, OAT; NEGRÃO, DR; SILVA, RC; FUNARI, CS; CESARINO, I .; LEAO, AL . Studies of lignin as reinforcement for plastics composites. Molecular Crystals and Liquid Crystals (Philadelphia, Pa.: 2003) , v. 628, p. 72-78, 2016.
PASSATORE, CR; LEAO, AL ; ROSA, DS . Preparation of Polypropylene Composites with High Levels of Coir Short Fiber for use in Products by Injection. Key Engineering Materials (Online) , v. 668, p. 28-38, 2016.
KC, B.; FARUK, O.; AGNELLI, JAM; LEAO, AL ; TJONG, J.; SAIN, M.. Sisal-glass fiber hybrid biocomposite: Optimization of injection molding parameters using Taguchi method for reducing shrinkage. Composites. Part A, Applied Science and Manufacturing , v. 83, p. 152-159, 2016.

Global Scientific Words in General Science